7A-2
1968
PONTIAC
SERVICE
MANUAL
2.
Insert tool J
4830-02
over output shaft and
tighten set screw.
3.
Attach slide hammer J 2619. Using hammer,
pull
bushing and seal from extension housing.
4.
Start
new bushing Into extension housing.
5. Using tool J
6403-1
and
soft
hammer, tap bush-
ing into place.
6.
Install
new seal, using tool J
6403-1
and collar
J
6403-2.
7. Reinstall drive shaft.
MAJOR REPAIRS
TRANSMISSION-REMOVE
1. Disconnect speedometer cable.
2. Disconnect shift control rods from transmission.
3.
Remove propeller shaft.
4. Support
rear
of
engine
and remove transmission
mount.
5. Remove four (4) crossmember
bolts
and slide
member
rearward.
6. Remove two (2) upper transmission to flywheel
housing
bolts
and insert guide pins.
7. Remove two (2) lower transmission to flywheel
housing attaching bolts.
8. Slide transmission straight back on guide pins
until
the main drive gear splines are free of splines
in
clutch friction plate.
9. Remove transmission.
INPUT
SHAFT
SEAL
REPLACEMENT
1. Remove transmission from car.
2. Remove input shaft bearing retainer.
3.
Remove seal from retainer by prying out with
screwdriver.
ALIGN SHIFT
LEVERS
IN
NEUTRAL
POSITION
BY
INSERTING
A
.186/.
185
DIA.
GAGE
PIN
THROUGH
(REV.
& 1st.)
HOLES
IN
LEVERS
AS
SHOWN
A
VERTICAL
<£ OF
COLUMN
FRAME
TRANSMISSION
ASSY.
k- i
i i
\y\
LEVER
(1st. &
REV.)
<$>
BRACKET
ASSY.
LEVER
(2nd. & 3rd.)
LUBRICANT
AS
INDICATED
WITH
CHASSIS LUBRICANT
Fig. 7A-1
Pontiac Column Shift Controls
To Next Page
Loading...
