7C-2
1968
PONTIAC SERVICE
MANUAL
^ FRONT
LEVER
(TRANS SHIFT CONT.)
(BUCKET
SEATS)
LEVER
ASSlY
(REV.
LEVER
ASSY (1ST
& 2ND),
LEVER
ASSY
(3RD ,
(TYPICAL
REV.
&
3RD,
4TH SHIFT ROD)
SHIFT
ROD
NUTS
„
TRUNNION
ASSY^^^^C-c^._^
(1ST
&
2ND)
S^&J
CIRCLE
Y
(1ST
& 2ND
SHIFT ROD)
VIEW
A
Fig.
7C-1 Tempest Shift Linkage
TRANSMISSION
SIDE
COVER-
ASSEMBLE
AND
INSTALL
1.
Install
shifter shaft O-rings if removed.
2.
Install
the 1st and 2nd
detent
cam
onto
the
detent
cam pivot pin, with the
detent
cam spring tang
projecting up over the 3rd and 4th shifter shaft
opening.
Install
the 3rd and 4th
detent
cam
onto
the
detent
cam pivot pin, with the
detent
cam spring tang
up over the 1st and 2nd shifter shaft opening.
NOTE:
Detent
cams
are not
interchangeable.
3.
Install
pivot retainer
C-ring
to pivot shaft and
hook spring into notches in
detent
cam spring tangs.
4.
Install
lst-2nd and 3rd-4th shifter shaft as-
semblies in cover, being careful not to damage seals.
Install
both shift forks to shifter shafts, lifting up on
detent
cams to allow forks to seat fully.
NOTE:
Shift
forks
are not
interchangeable.
5.
Install
reverse
detent
ball
and spring to cover,
then install reverse shifter shaft to cover.
6.
Install
outer shifter levers, flat washer, lock
washers and bolts.
7. Position shift forks in neutral position.
8. Position cover gasket on case and carefully po-
sition side cover into place, making sure the shift
forks
align with their respective sliding sleeves.
9.
Install
cover attaching bolts and torque evenly
to 20 lb. ft.
To Next Page
Loading...
