TURBO HYDRA-MATIC TRANSMISSION
7E-15
SEP.VO
COVER
ATTACHING SCREWS
Fig.
7E-20 Removing Rear Servo Cover Attaching Screws
BAND
APPLY
PIN
SELECTION
a.
Attach band apply pin and fixture J
21370-5
and
J
21370-6
to transmission case with attaching
screws.
b. Apply 25 ft. lb. torque and select proper pin
to be used during assembly of transmission.
There
are three selective pins identified as
follows:
a.
If both
steps
of J
21370-5
are below the
gauge
surface, the long pin, identified by 3 rings,
should be used.
b. If the
gauge
surface is
between
the steps,
the medium pin, identified by 2 rings, should be
used.
TORQUE
WRENCH-
J
21370-6
(PHI
J
21370-5
illijF
Fig.
7E-22
Checking Rear Band
Pin
c. If both
steps
are above the
gauge
surface,
the short pin, identified by 1
ring,
should be used.
Identification rings are located on band lug end of
the pin. Selecting the proper pin is equivalent of ad-
justing
the band.
5. Remove solenoid attaching screws, solenoid
assembly and.gasket (Fig.
7E-23).
6. Withdraw
detent
solenoid case connector
sleeve
and
O-ring
seal (Fig.
7E-24).
7. Remove control valve assembly spacer plate
and
gasket.
8. Remove six (6) check balls from cored pas-
sages
in transmission case (Fig.
7E-25).
Fig.
7E-21
Removing Rear Servo
Fig.
7E-23 Removing
Detent
Solenoid
and
Gasket
To Next Page
Loading...
