TURBO HYDRA-MATIC
TRANSMISSION
7E-31
Fig.
7E-73 Installing Pump Drive Gear
4.
Check
oil passages (Fig,
7E-75).
5.
Check
for damaged cover bolt attaching threads.
6.
Check
for overall flatness of pump body face.
7.
Check
bushing for scores or
nicks.
If replace-
ment is necessary, proceed as follows:
a.
Using tool J 21465-17, remove bushing.
b.
From
gear pocket side of pump and using
J
21465-17,
install
new bushing flush to .010".
8. Inspect pump attaching bolt seals for damage,
replace
if necessary.
9. Inspect pump cover face for overall flatness.
VENT
CONVERTER
COOLER
RETURN
_.TO
COOLER
LINE
,
MODULATOR
OR
INTERMEDIATE
DRIVE
Fig.
7E-75 Pump Body
Oil
Passages
10.
Check
for scores or chips in pressure regu-
lator
bore.
11.
Check
that all passages are open and not
inter-connected (Fig.
7E-76).
12.
Check
for scoring and damage at pump gear-
face.
13.
Inspect stator shaft for damaged splines or
scored bushing. If replacement of bushings is nec-
essary,
proceed as follows:
a.
Thread
J
21465-15
into stator shaft bushing.
Thread
slide hammer J 2619 into remover.
Clamp
slide hammer handle into vise.
Grasp
stator shaft
and
remove.
DRIVE
REVERSE
EXHAUST
, ,
LINE
MODULATOR
OR
INTERMEDIATE
'''•IllP
INTAKE-
TO
"COOLER
COOLER
RETURN
CONVERTER
^
>\ \
BREATHER
HOLE
-LUBE
LINE
VENT
Fig.
7E-74 Checking Pump Body Face
to
Gear
Face Clearance
Fig.
7E-76 Pump Cover
Oil
Passages
To Next Page
Loading...
