Pontiac firebird 1968 - Page 472

TURBO HYDRA-MATIC TRANSMISSION
7E-37
INTERMEDIATE CLUTCH SPRAG ASSEMBLY
SNAP RING
INTERMEDIATE CLUTCH RETAINER
INTERMEDIATE CLUTCH OUTER RACE
\
I \ \ \ DIRECT CLUTCH HOUSING
AND RACE ASSEMBLY
\
SPRAG BUSHINGS
DIRECT CLUTCH CENTER SEAL
DIRECT CLUTCH OUTER SEAL
DIRECT CLUTCH INNER SEAL
DIRECT CLUTCH PISTON
DIRECT CLUTCH PISTON RELEASE SPRINGS
DIRECT CLUTCH SPRING RETAINER
SNAP RING
\
Fig. 7E-91 Exploded View of Direct Clutch and Intermediate Sprag
2. Inspect sprag bushings for wear or distortion.
3. Inspect inner and outer races for scratches or
wear.
4. Inspect clutch housing for cracks, wear, proper
opening of oil passages or wear on clutch plate drive
lugs.
5. Inspect drive and driven clutch plates for sign
of wear or burning.
6. Inspect backing plate for scratches or other
damage.
7. Inspect clutch piston for cracks and free op-
eration of ball check.
ASSEMBLY OF DIRECT CLUTCH AND
INTERMEDIATE SPRAG
1. Install a new inner clutch piston seal on piston,
DIRECT CLUTCH
J 6129
-J 4670
~~ J 8765
SNAP RING
Fig. 7E-92 Removing Direct Clutch Snap Ring
Fig. 7E-93 Removing Direct Clutch Piston