Pontiac firebird 1968 - Page 474

TURBO HYDRA-MATIC TRANSMISSION 7E-39
J21362
J 21409
Fig. 7E-98 Installing Direct Clutch Piston
CHECK BALL
/
BLIND HOLES
• t
\
/
DIRECT CLUTCH
FORWARD CLUTCH
^ DIRECT CLUTCH
BACKING PLATE
. FLAT STEEL PLATES (4)
^ COMPOSITION PLATES (5)
- WAVED STEEL PLATE (1)
4^
,1
NOTE: 5 FLAT
STEEL PLATES-
NO WAVED STEEL
PLATE IN PQ
MODEL
Fig. 7E-101 Installing Direct Clutch Backing Plate,
Composition Plates and Steel Plates
10. Install backing plate retaining snap ring (Fig.
7E-102).
11. Turn unit over and install one spring bushing,
cup side up, over inner race.
12. Install sprag assembly into outer race.
13. With ridge or shoulder on inner cage down,
start sprag and outer race over inner race with
clockwise turning motion (Fig. 7E-103).
NOTE: Outer race should not turn counterclock-
wise after installation.
Fig. 7E-99 Identification of Direct Clutch Piston
^ . J 6129
1 J 4670
•BflBHL^
- A J 8765
flSBSHB
. SNAP RING
Fig. 7E-100 Installing Direct Clutch Spring Retainer
and Snap Ring
Fig. 7E-102 Installing Direct Clutch Housing
to Backing Plate Snap Ring