Pontiac firebird 1968 - Page 477

7E-42
1968 PONTIAC DIAGNOSIS MANUAL
INTERMEDIATE CLUTCH
PISTON
' mm
i
CLUTCH INNER SEAL
Fig. 7E-110 Installing Intermediate Clutch Inner Seal
pockets of piston into cored areas of center support
(Fig. 7E-112).
3. Install three (3) release springs into counter-
bores of piston. Space equally during assembly.
4. Place spring retainer and snap ring over
springs.
5. Using clutch spring compressor J 4670 and
J 6129, compress springs and install snap ring
(Fig. 7E-113).
6. Install four (4) hook type oil rings.
7. Air check operation of intermediate clutch
piston (Fig. 7E-114).
-J 21363
t
mm
1
m
4
- CENTER
SUPPORT
Fig. 7E-112 Installing Intermediate Clutch Piston
m
mm^mwmmmm^-
;
' s>
Fig. 7E-113 Installing Intermediate Clutch Piston
Snap Ring
INTERMEDIATE CLUTCH PISTON
TmWBKmJ :*
-CLUTCH OUTER SEAL
Fig. 7E-111 Installing Intermediate Clutch Outer Seal
Fig. 7E-114 Air Checking Intermediate Clutch Piston