TURBO
HYDRA-MATIC TRANSMISSION
7E-51
#
5
1 wJ
THRUST
WASHER
Fig.
7E-137 Installing
Case
to
Output
Shaft Thrust Washer
5. Install parking brake bracket
guides
over park-
ing pawl, using two attaching bolts. Torque to 18
lb.
ft.
6. Install rear band so that two
lugs
index with
two anchor pins. Check to make sure band is seated
on
lugs
(Fig. 7E-142).
7. Install proper rear selective washer (proper
washer determined by previous end play check) into
slots
provided inside rear of transmission case.
mKmm
•I
to
mm
-PARKING
PA'M
MjNiNNI
\WEL\\W^
PARKING
PAWL
SHAFT
„
RETAINING SPRING
SHAFT
Fig.
7E-139 Installing Parking Shaft Retaining Spring
H
Fig.
7E-140 Installing
New Cup
Plug
A
Fig.
7E-138 Installing Parking Pawl
and
Shaft
with
O-Ring
Fig.
7E-141 Installing Parking Pawl Return Spring
To Next Page
Loading...
