7F-4
1968 PONTIAC
SERVICE
MANUAL
HANDLE MUST
BE
INSTALLED
AFTER
CONSOLE
PARTS ARE ASSEMBLED
STARTER
NEUTRALIZER SWITCH INSTALLATION
1.
POSITION GEARSHIFT
LEVER
IN
DRIVE POSITION.
2.
INSERT SWITCH DRIVE TANS
IN
SWITCH
LEVER
AND
ASSEMBLE
SWITCH
TO
SHIFTER ASSEMBLY.
3. INSERT ADJUSTING
GAGE
IN
SWITCH. MOVE GEARSHIFT
LEVER
TO
PARK POSITION
&
REMOVE ADJUSTING
GAGE
SWITCH
RESET
(IF
RE-ADJUSTMENT
IS
REQUIRED)
4.
INSERT BLADE
OF
RESET
GAGE
IN
SLOT
5. MOVE GEARSHIFT
LEVER
SLOWLY
TO LOW
POSITION.
6. REMOVE
RESET
GAGE
AND
REPEAT
STEP
3.
UNDERBODY
ADJUSTMENT
GAGE
TRANSMISSION
ROTATE
TRANSMISSION
LEVER
CLOCKWISE
TO
"PARK" POSITION.
ADJUST
PIN TO
THIS
DIMENSION
PRIOR
TO
INSTALLATION
OF
CABLE.
VIEW
C
Fig.
7F-3
Tempest Floor
Shift
Linkage
2. Remove speedometer cable and speedometer
driven
gear assembly,
3.
Remove
rear
bearing retainer.
4. If necessary, replace speedometer drive gear.
Remove by depressing clip (Fig. 7F-27),
Install
new
gear.
5. Pry out old oil seal.
6. Remove old case to
rear
bearing retainer oil
seal.
7. Remove old
rear
bearing retainer bushing, using
bushing chisel J
8400-1
(Fig.
7F-9).
8.
Install
new bushing from
rear,
using installer
J
21424-1
and handle J
8092
(Fig. 7F-10).
9. Coat outer casing of new oil seal with gasket
sealing compound and drive it into place with in-
staller
J 5154 (Fig.
7F-8).
10.
Install
new case to
rear
bearing retainer oil
seal.
11
o
Install
rear
bearing retainer. Tighten
bolts
to
30 lb. ft. torque.
12.
Install
propeller shaft (see section 4C).
13.
Install
speedometer driven gear and connect
cable.
GOVERNOR
REMOVAL
1. Remove three
bolts
retaining governor cover to
case. Remove cover and gasket.
To Next Page
Loading...
