STEERING
9-3
10
WHEEL
MUST
NOT
VARY
MORE
THAN
5
DEGREES FROM HORI-
ZONTAL WHEN FRONT WHEELS
*
ARE
IN
STRAIGHT AHEAD POSITION.
1
fl
4*
Fig.
9-2
Locating
Steering
Wheel
Position
removing two retaining clips between bezel and in-
side of switch cover.
4. Push in
hazard
warning knob and unscrew knob.
Fig.
9-4
C-Snap
Ring,
Thrust
Washer,
Wave
Washer
8. Remove the steering column mounting bracket
from
the steering column to provide clearance so
that the wiring and curved connector can be re-
moved.
This
can be accomplished by removing the
four short
bolts
attaching bracket to steering column,
also remove two nuts and
wedge
bolt that attaches
bracket
to the instrument panel. Remove
wedge
shaped shim placed between bracket and instrument
panel
brace.
5. Remove snap
ring
from upper steering shaft by
sliding sideways out
groove
with tool J 22569. Do
not pry against switch (Fig. 9-3).
6. Slide thrust washer and wave washer off upper
steering shaft (Fig. 9-4).
7. Disconnect
turn
signal switch wiring harness at
connector under instrument panel.
NOTE:
Always
hold the steering column
against
the instrument panel when mounting bracket is re-
moved.
Do not
allow
the steering column to drop
downward.
WIRING
HARNESS COVER
Fig.
9-3
C-Snap
Ring
RemovaI
Fig.
9-5
Removing
Wiring
Harness
Cover
To Next Page
Loading...
