11-4
1968
PONTIAC
SERVICE
MANUAL
Fig.
11-4
Pontiac
Front
Fenders
insulator
(Figs.
11-7, 9, 10). Special attention is re-
quired
to ensure that the
sheet
metal is resting on
these
mounts and not being supported by the fender
to shroud attachments. For this reason, the fender
to shroud attachments must be
loosened
and re-
adjusted
whenever the front mounting is disturbed.
and
from rocker panel
area.
6. Remove fender.
B.
REPLACEMENT
FRONT
FENDER-
REMOVAL
AND
REPLACEMENT
A.
REMOVAL
NOTE:
If the
same
fender
is to be
replaced,
note
position,
location
and
number
of
alignment
shims
used.
1. Remove valance panel and front bumper
assembly.
2.
Remove fender to support and baffle assembly
attaching screws.
3.
Remove hood hinge to fender attaching screws.
4.
Remove fender to inner
skirt
attaching screws
at wheelhouse.
5.
Disconnect fender from cowl at door opening
1. To install, reverse
above
procedure.
2.
Align fender with other
sheet
metal and body
parts.
3.
Torque all fender to cowl and rocker panel
attaching screws 30 lb. ft., all fender-to-fender
inner
skirt
and fender to fender extension attaching
screws
12 lb. ft. and all fender extension and upper
grille
panel attaching screws 12 lb. ft.
FRONT
INNER
FENDER
REMOVAL
(PONTIAC
AND
TEMPEST)
A.
REMOVAL
1.
Lift
front end on frame allowing front sus-
pension to hang free.
To Next Page
Loading...
