15-32
1968
PONTIAC
SERVICE
MANUAL
© OUTER
©
QUARTER
O PANEL
Fig.
15-44
Electric Antenna—Pontiac Wagon
10. Remove
bottom
insulator and water seal
washer from tubular fitting, using wire hook or long-
nose
pliers.
11.
Thread
nylon cord through
bottom
insulator
with
small diameter end down.
Then
thread nylon
cord
through water seal washer.
12. Apply 12 volts D.C. (down direction of mast)
to power leads and
feed
nylon cord into drive assem-
bly.
Do not allow bend or
kink
to occur in nylon cord.
NOTE:
Push
water
seal washer and
bottom
in-
sulator
all the way
down
into
tubular
fitting
before
nylon cord
completely
disappears
into
drive
as-
sembly.
Remove
power,
if necessary, to
seat
these
parts.
EXISTING
WIRE
ASSY
Fig.
15-45
Electric Antenna —Ternpest
13. Push .400 tube section down into tubular fitting
on drive. Make sure that upper
edge
of flange on
insulator bushing is below center of 3
holes
in tubu-
lar
fitting.
14.
Install
support tube (minus lead-in flange, pin
and
insulator assembly) in proper position, making
sure
hook-up wire is extended through proper
hole
in
support tube.
15.
Install
three screws to hold support tube to
drive
assembly.
16. Solder hook-up wire to pin and insulator
assembly.
CA
UTION:
Do not
overheat
by
slow
soldering.
17. Assemble flange over pin and insulator assem-
bly and install two screws.
To Next Page
Loading...
