8
Setting The Time
Press the menu button four times and press enter. Each program can be turned on by
pressing the up button and turned off by pressing the down button. Press enter again
and adjust the start time with the up and down buttons as necessary. Press enter again
and adjust the stop time with the up and down buttons as necessary.
Setting The Winter Modes
Winter mode 1 will reduce the pump run time in program 1 by 1 hour and it will reduce
chlorine output by 20%. Winter mode 2 will reduce the pump run times in
programs 2 and 3 by 1 hour each. It will also reduce chlorine output by a further 20%.
To operate the winter mode settings, press the menu button five times and press enter.
Each program can be turned on by pressing the up button and turned off by pressing
the down button. Press enter again and adjust the start month with the up and down
buttons as necessary. Press enter again and adjust the start day with the up and down
buttons as necessary. Press enter again and adjust the stop month with the up and
down buttons as necessary. Press enter again and adjust the stop day with the up and
down buttons as necessary.
This setting is useful for pools with limited use during colder months and will save
energy costs each year.
Changing The Settings
Press the menu button 6 times and press enter. The system will display the beeper
control. It can be turned on by pressing the up button and turned off by pressing the
down button. To set the year, press enter again and adjust with the up and down
buttons as necessary. To set the month, press enter again and adjust with the up and
down buttons as necessary. To set the day, press enter again and adjust with the up
and down buttons as necessary. To set the time, press enter again and adjust with the
up and down buttons as necessary.
Pressing enter again will display the program version number, the model number and
the vendor phone number.
Accessing the System History
Press the menu button 8 times and press enter. The system will display the number of
hours that it has run with low salt. Press enter again and it will display the number of
hours that the system has operated with insufficient water in the cell. Press enter again
and it will display the number of times that the system has switched off due to loss of
pump prime. Press enter again and the system will display the number of times that the
system has switched off due to power spikes. Press enter again and the system will
display the number of hours that it has operated at high temperature. Press enter again
and the system will display the number of times that it has shut down due to high
temperatures. Press enter again and the system will display the number of hours that
it has operated since the last service.
Messages
If the system has switched off, it will sound an alarm every minute and display the
reason. To reset the system press the on button. Not all alarms will turn off the unit,
only those which may cause damage.
To Next Page
Loading...