Porsche 968 - Wipers and Washer Systems; Wiper;Washer Stalk Operation; Windscreen Washer System; Headlight Cleaning System

Wiper/Washer Stalk
The wiper / washer stalk has 7 positions:
0 - Wipers off
l - Slow wiping speed
Fa st wiping speed
3 - Very fa st wiping speed
4 - Intermittent wipe
5, 6 - Windscreen Washer System
-
By pulling the stalk towards the steeril')g wheel,
the windscreen washer pump is operated in
switch position "5". When the stalk is released ,
the wipers wipe the windscreen a few times.
In switch position "6", the windscreen washer
pump and wipers operate together .
Before operating the wiper system, the wind-
screen must be sufficiently wet to prevent the
glass from being scratched . Check your wiper
bladers regularly and replace at least once a
year .
With the ignition on, the windscreen washer noz-
zles are heated .
7 -
Headlight Cleaning System
With the lights on (high or dipped beam head-
lights) the system is operated by briefly pressing
the wiper/washer stalk towards the instrument
panel.
The washer pump supplies water under high
pressure to the spray nozzles located in front of
the headlights : The spray duration is limited by a
relay, so if the headlights are particularly dirty,
repeat the process as necessary. Stubborn dirt
(e.g. dried - on insects) should be removed regu-
larly.
'
"%] Wipe Interval
The wipe intervals can be regulated to any set-
ting by turning the knurled knob .
37