Porsche E-Performance - Operation and Maintenance; Closing and Initial Operation; Cleaning and Technical Data

19
Bringing into operation / Operation
EN
DE
ES
FR
IT
JP
KO
NL
PTB
RU
ZH
ZHT
Closing the charging pedestal
1. Fit the panel on the two stud bolts in the lower
part of the pedestal.
2. Close the panel.
3. Lock the front panel with the key.
Fig. 11: Closing the charging pedestal
Bringing into operation /
Operation
Cleaning
Plexiglas:
▶ Clean the Plexiglas with water, liquid detergent
and a cloth.
Aluminium housing:
▶ Clean the aluminium housing with lukewarm
water (~25 °C) and a soft cloth. To remove coarse
dirt, use only pH-neutral soap. Allow this
to soften the dirt for a short time, then wipe off
with a cloth.
Spare parts
Technical data
1
2
3
Information
Have the electrical installations used for charging
checked regularly by a qualified electrician.
NOTE
Do not use highly abrasive, scratchy cleaning
materials, hard objects or steel wool.
Plug holder with adapter set 971.044.031
Foundation fastening kit 971.044.032
Spare key 971.044.034
Information
To order another key, you will need the lock cylinder
number. This is stamped on the lock cylinder or
the key.
Mechanical data
Dimensions of charging
pedestal
(width x height x depth)
190 (263) x 1670 x
150 mm
Weight of charging pedestal approx. 20.1 kg
Environmental conditions
Operating temperature -25 to +35 °C
Humidity 5 – 95%
non-condensing
Altitude max. 4,000 m
above sea level