IMPORTANT SAFETY INSTRUCTIONS
FOR PNEUMATIC TOOLS
save these instructions
When using any pneumatic tool, all safety precautions, as outlined below,
should be followed to avoid the risk of death or serious injury. Read and understand all
instructions before operating the tool.
DEFINITIONS - SAFETY GUIDELINES
The definitions below describe the level of severity for each signal word. Please read the
manual and pay attention to these symbols.
Indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a potentially haz ard ous situation which, if not avoided, may
result in minor or mod er ate injury.
Used without the safety alert symbol indicates potentially hazardous
situation which, if not avoided, may result in property damage.
glasses with side shields. These safety glasses must
conform to ANSI Z87.1 requirements (approved glasses
have “Z87” printed or stamped on them). It is the employer’s
responsibility to enforce the use of eye protection equipment
by the tool operator and other people in the work area.
(Fig. A)
to appropriate setting.
protection during use. Under some conditions and
to hearing loss. (Fig. A)
an air compressor can rust and damage the internal
(Fig. B)
[Not to exceed 120
psi (8.3 bar).] Do not connect the tool to a compressor
rated at over 175 psi. The tool operating pressure must
never exceed 175 psi even in the event of regulator failure.
(Fig. C)
(Fig. D)
70 psi
4.9 bar
Fig. C
Fig. B
Fig. A
Fig. D
To Next Page
Loading...
