Never use combustible
gases or any other reactive gas as a power source for this
tool. Danger of explosion and/or serious personal injury
may result. (Fig. E)
compressor when the tool is disconnected. (Fig. F)
passing the tool to another operator. Do not carry
tool to another work area in which changing location
air supply. If the contact trip is adjusted when the tool
is connected to the air supply and nails are loaded,
accidental discharge may occur. (Fig. G)
•
connected to the air supply. Do not load fasteners with
trigger or safety depressed to prevent unintentional firing
of a fastener.
Do not tape or tie trigger or contact trip in the on
position. Do not remove spring from contact trip. Make
daily inspections for free movement of trigger and contact
trip. Uncontrolled discharge could result.
•
Leaking
air, damaged parts or missing parts should be repaired or
replaced before use. Refer to Repairs. (Fig. H)
Fig. I)
time. No horseplay! Work safe! Respect the tool as a
working implement. (Fig. J)
•
operating a power tool. Distractions can cause you to
lose control. When tool is not in use, it should be locked
in a safe place, out of the reach of children.
Fig. E
Fig. F
Fig. I
Fig. J
Fig. G
Fig. H
To Next Page
Loading...
