Porter-Cable PCX18125P - Unit Cleaning and Storage; TROUBLESHOOTING; Common Issues and Solutions

9
CLEANING
To keep the wet/dry vacuum looking its best, clean the outside with a cloth dampened
with warm water and mild soap.
To clean the tank:
STORAGE
Before storing the vacuum, the dust tank should be emptied and cleaned. The cord
should be wrapped and hung on the unit and the accessories should be kept in the
accessory holder so they can be readily available. The vacuum should be stored
indoors.
1. Dump out debris.
2. Wash tank thoroughly with warm water and mild soap.
3. Wipe out with dry cloth.
NOTICE
Clean the filter in an open area.
TROUBLESHOOTING
WARNING!
Minor problems often can be fixed without calling customer service.
Vacuum will not
run
Loss of suction,
wet pick-up
Loss of suction,
dry pick-up
No electricity
1. Full tank
2. Clogged hose
3. Clogged filter
1. Drain and clean tank
2. Remove hose and clean debris
3. Clean or replace filter
Make sure electrical outlet has voltage
(A qualified electrician may need to be contacted)
1. Full tank
2. Clogged hose
3. Clogged filter
1. Drain and clean tank
2. Remove hose and clean debris
3. Clean or replace filter
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION