6
WARNING!
OPERATING INSTRUCTIONS
UNPACKING & SET-UP SUMMARY
MOUNTING WALL BRACKET
1 . Remove the power head by pushing on the side lugs with thumbs and lifting up on the
tabs on the tank cover.
2. Before replacing power head, please refer to Dry Pick-up or Wet Pick-up Operation in
this manual to ensure you have the proper filters installed for your cleaning operation.
3. Replace power head on the tank by aligning tabs with lugs. Press down firmly on the
upper housing until power head snaps into place.
4. Insert the hose end with locking-ring into the vacuum port and tighten. Do not
over tighten.
5. Attach one of the accessories to the end of the hose. Twist slightly to tighten
the connection.
6. Plug the cord into the wall outlet. Your cleaner is ready for use. I = On, O = Off
To reduce the risk of fire or explosion, do not operate this vacuum in areas with
Mount the wall bracket to a wall stud. Secure with hardware provided.
flammable gases, vapors or explosive dust in the air. Flammable gases or vapors
include but are not limited to: lighter fluid, solvent-type cleaners, oil-based paints,
gasoline, alcohol or aerosol sprays. Explosive dusts include but are not limited to: coal,
magnesium, aluminum, and grain or gun powder. Do not vacuum explosive dust,
flammable or combustible liquids or hot ashes. Do not use this vacuum as a sprayer for
any flammable or combustible liquid. To reduce the risk of health hazards from vapors
or dusts, do not vacuum toxic materials.
WARNING!
The operation of any utility vacuum can result in foreign objects being blown into the
eyes, which can result in severe eye damage. Always wear safety eyewear complying
with ANSI Z87.1 (or in Canada, CSA Z94.3) before starting operation.
CAUTION:
To reduce risk of hearing damage, wear ear protectors when using the vacuum for
extended hours or when using it in a noisy area.
NOTICE
An inadequately mounted wall bracket could become loose and fall, causing injury or
damage to the wet/dry vacuum. The location used to mount the wall bracket should be
strong enough to hold the combined weight of the vacuum and accessories.
O = OFF I = ON
To Next Page
Loading...
