31
3. The three indicators stop blinking and remain lit, the printer is back to
a normal state.
Self Test
1. Press and hold the Pause/Self Test button for about 4 seconds;
2. The printer will print out a configuration report and the three
indicators will stop blinking and remain lit. The printer is back to a
normal state.
3. The following information will be printed on the self-test report:
- Font list
- Hardware configuration and status
- DIP switch settings
- Label parameters
- Firmware version
Reset – Reset the Printer to the Factory Default Settings
Following the steps listed below allows you to reset the printer to the
factory default settings.
1. Press and hold the Cancel/
Reset button for 4 seconds, the three
lamps will blink simultaneously (the printer will return to normal
state automatically if no operations are performed within 4 seconds);
2. Release and press the Cancel/
Reset button again;
3. The three indicators stop blinking and remain lit. The printer is now in
its normal state.
The following parameters have automatically been reset:
- Label
- Print darkness
- Speed
- Others
Note: The printed label count and printed length may not be reset.
To Next Page
Loading...
