Postek G-3106 - Page 24

G-2108/G-3106 User’s Manual Chapter 3: Operations and Settings
20
LED Indicator
Description
• If only the [READY] indicator is blinking, then the printer is paused
and awaiting further instruction
[MEDIA]
• If the indicator is on, it means the printer is at a normal working
state
• If both the [READY] and [MEDIA] indicators are blinking, then the
printer detected media out
[RIBBON]
• If the indicator is on, it means the printer is using thermal transfer
mode (Requires ribbon)
• If the indicator is off, it means the printer is using direct thermal
mode (No ribbon required)
• If both [READY] and [RIBBON] indicators are blinking, then the
printer detected ribbon out
Panel Buttons
The three buttons on the front of the printer, please refer to Table 3-2 below for details regarding
their functionality.
Table 3-2 Panel Button Description
Button
Basic Functions
Advanced Functions
(Press and hold for 4 seconds)
[FEED/Calibration]
When printer is in a standby
state, press once and the printer
would feed one label
Media Calibration
[PAUSE/Self Test]
• When printer is in working
or standby state, press once
to pause the printer
• When printer is in a paused
state, press once to resume
Self-test:
The Printer performs a self-test and
prints out a configuration report
[CANCEL/ Reset]
When printer is in an error state,
press once to clear the error
report
Reset:
Resets the printer to Factory Default
Settings