To Next PageTo Next Page
Need help?Do you have a question about the Potter EVD-2 and is the answer not in the manual?
General| Brand | Potter |
|---|---|
| Model | EVD-2 |
| Category | Security Sensors |
| Language | English |
Lists key capabilities of the EVD-2 system, including detection, sensitivity, and expandability.
Details physical dimensions, weight, enclosure, power input, current draw, and contact data.
Provides stock numbers for the EVD-2 system, controller, remote pickup, and optional accessories.
Explains the accumulator function controlled by a rotary switch for accumulating impact events.
Details the internal components and connections of the EVD-M controller, including its microprocessor and status LED.
Lists and describes the function of each terminal on the EVD-M controller for power and accessories.
Illustrates the locations for end-of-line resistors on EVD-M and EVD-R units for network termination.
Details the internal components and connections of the EVD-R remote pickup, including its tamper switch.
Lists and describes the function of each terminal on the EVD-R remote pickup for sensor input and safe contact.
Provides detailed wiring instructions, cable clamp usage, jumper settings, and network limitations.
Specifies appropriate UL listed wire types for control unit, remote pickup, and test/annunciator connections.
Provides step-by-step instructions for installing the EVD-2 system, including wiring and resistor configuration.
Illustrates wiring configurations for the EVD-M controller with safe detector zones and 24-hour alarm zones.
Illustrates wiring configurations for the EVD-M controller with safe detector zones using 4-conductor shielded cable.
Lists analog test point voltage levels for various signal conditions to aid in sensitivity adjustment.
Details maximum linear distances from detector to safe surface based on construction material and sensitivity settings.
Provides a table of common safe dimensions and their corresponding maximum linear distances for detector placement.
Outlines UL requirements for installing EVD-2 systems in vaults, including detector placement and standby power.
Explains detector spacing and coverage areas for wall protection applications, referencing material and sensitivity settings.
Provides detailed mechanical dimensions for the EVD-M and EVD-R units in inches.
