Do you have a question about the Potterton Apollo and is the answer not in the manual?
Provides detailed instructions for installing the condensate discharge pipework to prevent freezing and blockages.
Provides guidelines for siting balanced flue terminals, including minimum distances and guards.
Provides detailed instructions for fitting the plume displacement kit components.
Steps for unpacking the boiler and preparing for wall mounting.
Details how to lift and securely attach the boiler to the wall plate.
Instructions for connecting the discharge pipe to the safety pressure relief valve.
Connects the condensate drain to the trap outlet pipe, adhering to regulations.
Guides on fitting the horizontal flue, including measurements and cutting.
Continues instructions for fitting the flue, including support brackets and trim.
Explains how to connect external controls like room thermostats to the boiler.
Lists essential electrical checks to perform before commissioning the boiler.
Step-by-step guide for the initial commissioning of the boiler system.
Details how to check and set the gas inlet pressure and measure gas rate.
Recommends annual servicing and details competence requirements for combustion checks.
Outlines the inspection steps required during annual servicing of the boiler.
Continues the inspection steps for annual servicing, including fan and filter checks.
Instructions for replacing the boiler's igniter unit.
Details the procedure for replacing the electrode assembly.
Step-by-step guide for replacing the boiler's fan assembly.
Procedure for replacing the burner and its associated components.
Instructions for replacing the safety thermostat.
Instructions for replacing the Printed Circuit Board (PCB) of the boiler.
Instructions for replacing the gas valve, including initial setup.
Explains how to check and adjust the gas valve using CO2 readings.
Lists basic checks to perform before diagnosing faults with the boiler.
Explains the error codes displayed by the boiler and their meanings.