Mounting Your RAZOR
Choosing the best mounting location for your RAZOR amplifier is crucial. The amplifier should be mounted
to any wood, metal, or carpeted surface. The heat-sink can be mounted directly to the chassis of the car or
isolated for best performance. II needs proper ventilation, so avoid mounting the amp under seats, engine
bay, or any other area that moisture might accumulate. Be sure the mounting screws do not penetrate the
fuel tank, brake lines, or other crucial fluid lines. Never mount the amplifier to a subwoofer enclosure, as
excessive vibrations can cause damage.
Warning!!
Power Acoustik highly recommends that an in-line fuse or circuit breaker be installed within 18" of
the battery. Although your RAZOR amplifier has adequate internal protection, a damaged wire
between the component and the battery may result in a fire. The in-line fuse or circuit breaker should be
installed in a location that is easy to access, and all wiring should be routed safely, following the below
suggestions:
-
Avoid placing wires near hot or moving objects
-
Always use wire grommets when routing wire through the firewall or any other metal surfaces
-
Avoid the potential for damaged wires by routing all wires away from moving hinges, seats, brake
& gas pedals, hood and trunk hinges, etc.
6
To Next Page
Loading...
Need help?
General
