- Remove the 3 screws from the Atomizer Plate Cover.
- Remove the 3 screws from the Atomizer Plate.
- The center of the plate is now visible, on the sha are the (2) set screws; make sure they
are not loose.
- The plate can now be removed from the sha exposing the pipe.
- Ensure the pipe is clear of any debris.
- Turn on the atomizer and allow the water to flow out.
- Re-assemble atomizer.
If the problem is not resolved, contact Customer Service by email at
customerservice@powerbreezer.com or by phone at 844-233-5673.
End of secon
To Next Page
Loading...