Power Breezer Mach 4+ - Water Pump Not Working Properly

Water Pump Not Working Properly
Make sure to unplug the unit while checking connecons or anything pertaining to the
electronic box and plug back in when tesng.
Possible Causes of Pump Failure:
1. Water Hose
2. Wiring of the E-Box
3. Control Panel
4. Water Pump
Note
Since the pump has a “Safe - Mode” to prevent the pump from being damaged from running
without water, always unplug the unit and wait 30 seconds to clear any debris in and around the
pump. Then, plug the unit back in and test to verify failure.
Troubleshoong
Step 1 Water Hose
- Turn on the unit.
- Turn on the atomizer.
- Trace the hose.
a. If the hose is leaking ensure the hose is pushed past the “O” ring in the adapter.
b. Verify the hose is connected to the water valve and the valve is connected to the
Atomizer.
c. Verify the valve is turned on; this is when the blue arm is parallel to the body of
the valve.
- Verify the hose is not clogged.
a. Using compressed air, take the nozzle, blow into the Water Feed Tube to the
Atomizer for 2–3 seconds. Reconnect the Water Feed Line and test.
b. If it is misng (Water flow), the problem is resolved.
c. If the hose was not clogged, go to step 2.
Step 2 Wiring of the E-Box
- Open E-Box.
- Compare the E-Box to the drawing 180-700-750 wiring diagram.
- If the E-Box is not wired correctly, fix the issue and re-test.
- If the E-Box is wired correctly, go to step 3.