Power Breezer Mach 4+ - Page 13

Step 4 Rotaon Motor Assembly
- To access the Rotaon Motor:
a. The head must be placed on the side or back into the tank.
b. The hex screw, on the boom of the rotaon pipe, must be removed.
c. The rotaon pipe must be lied out of the Breezer.
d. The panel above the E-Box now can be removed and the rotaon motor with its
linkage can be viewed.
- Look at drawing 140-700-300, Tank Rotaon Assembly, and verify the rotaon motor
with its linkage is connected as it is depicted in the drawing 140-700-300.
a. If it is not, correct the misassembly according to the diagram and re-test.
b. If it is correct and sll not working properly, contact Customer Service by email at
customerservice@powerbreezer.com or by phone at 844-233-5673.
End of secon