6
© Copyright 2016 Power Electronics
®
International Inc. 561-8 Plate Drive, East Dundee, Illinois 60118-2467 USA
Next hold the scroll button until you are back to the OFF screen. It’s a simple as that! The settings from the Gang-Set
®
have now been loaded into your drive.
A video of the Gang-Set procedure can be viewed here.
How can I adjust the motor speed settings of my drive?
Nearly all of the motor speed and acceleration/deceleration settings can be adjusted within the “A” parameter group.
The most common adjustments can be performed by changing the following parameters:
A1: This is your default acceleration time in seconds. The value of this parameter determines how long it will take for
your drive to ramp your motor from zero to full speed.
A4: Default deceleration time in seconds. This value determines how long it will take to ramp down from full speed to
zero.
A12: This is usually your default low speed setting, in Hz.
A13-A16: Speed settings associated with inputs S2-S5, respectively.
More information about basic programming procedures, as well as a more complete list of the “A” parameters can be
found HERE. You can also refer to your drive’s manual for more information about the other parameter groups.
To Next Page
Loading...
Need help?
General
