Power Electronics VS65 Series Programming And Software Manual

VS65 SERIES MV SOFT STARTER
POWER ELECTRONICS
10
SAFETY INSTRUCTIONS
WARNINGS
RECEPTION
 The VS65 Series soft starters are handled carefully tested and perfectly packed.
 In the even of transport damage, please ensure that you notify the transport agency and Power
Electronics: 902 40 20 70 (International + 34 96 136 65 57).
UNPACKING
 Verify model and serial number of the soft starter is the same on the box, delivery note and unit.
 Each soft starter is supplied with an installation manual.
RECICLYING
 Packing of the equipments should be recycled. Therefore, it is necessary to separate materials included
(plastic, paper, cardboard, Wood….) and deposit them on proper recycling banks.
 Waste products of electric and electronic devices should be selectively collected for their correct
environmental management.
SAFETY
 Before starting the soft starter, read this manual completely to gain an understanding of the unit. In case
of doubt, please contact Power Electronics (902 40 20 70 / +34 96 136 65 57) or your nearest agent.
 Wear safety goggles when operating the soft starter with voltage.
 Handle the equipment in accordance with the soft starters’ weight.
 Proceed with the installation according to the instructions found in this manual.
 Do not stack the soft starter or place heavy objects on the soft starter.
 Ensure that the soft starter is correctly installated considering the recommendations within this manual.
 Do not drop the soft starter or to impact exposure.
 The VS65 Series soft starters contain static-sensitive printed circuit boards. Use static safety procedures
when handling boards.
 Avoid installing the soft starter in different conditions form those described in the Technical
Characteristics section.

Power Electronics VS65 Series Specifications

General

Brand	Power Electronics
Model	VS65 Series
Category	Controller
Language	English