EasyManua.ls Logo

Power Master PM-2500 - Operation; Operating Procedures

Power Master PM-2500
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
O
F
F
O
N
ON
E
C
O
N
.
S
W
O
F
F
O
N
E
N
G
I
N
E
S
W
I
T
C
H
O
N
O
F
F
3GROUND (Earth)
Make sure to ground (earth) the generator.
6. OPERATION
NOTE: ────────────────────────
z The generator has been shipped without engine oil. Fill with oil or
it will not start.
z Do not tilt the generator when adding engine oil. This could result
in overfilling and damage to the engine
───────────────────────────
1STARTING THE ENGINE
NOTE: ──────────────────────
z Do not connect any load to the generator until the generator has
been started and is running smoothly
z Turn the economy control switch to the “OFF” position.
─────────────────────────
1. Open the fuel tank air vent to the “OPEN” position.
2. Turn the fuel cock lever to the “ON” position.
3. Turn the engine switch to the “ON” position
4. Turn the choke lever to the “ ”position. Not necessary if the
engine is warm.
5. Pull the starter handle slowly until resistance is felt. This is the
“Compression” point. Return the handle to its original position and
pull swiftly. After starting, allow the starter handle to return to its
original position while still holding the handle. Hold the carry handle
of the generator firmly to avoid the generator from falling over when
pulling the recoil starter.
6. Allow the generator to warm up before returning the choke lever to
its original position.
7. Allow the generator to run without a load for a few minutes.
2USING ELECTRIC POWER
1. AC APPLICATION
a. Check the AC pilot lamp to see the voltage output.
OPEN

Related product manuals