18
1）DRAIN THE FUEL
1. Remove the fuel tank cap and drain the fuel from the fuel tank
2. Remove the cover and drain the fuel from the carburetor by loosening the drain screw.
2）ENGINE
a. Remove the spark plug and pour in about one tablespoon of SAE 10W30 or 20W40 motor oil into
the spark plug hole and reinstall the spark plug.
b. Use the recoil starter to turn the engine over several times (with ignition off).
c. Pull the recoil starter until you feel compression.
d. Stop pulling.
e. Clean the exterior of the generator and apply a rust inhibitor.
f. Store the generator in a dry, well-ventilated place, with the cover place over it.
g. The generator must remain in a vertical position.
To Next Page
Loading...
