13
4. Slide out the power supply pair of boards.
5. Insert, as a pair, the new bottom power supply (connect to side socket)
and the top power supply (connect to the CPU board).
6. Re-insert the communications board, the I/O card (if applicable) and the
display board.
7. Re-place the cover with the four side screws (taking care not to pinch any
of the wiring) and connect the ground wire.
8. Re-insert the shield with its two screws.
9. Re-insert the cover by aligning the rim slots and press down, twisting
clockwise. Secure with new base seal provided.
To Next Page
Loading...
