Need help?Do you have a question about the Power-Pole CM2 HPU and is the answer not in the manual?
General| Power Source | Electric |
|---|---|
| Max Pressure | 3000 psi |
| Flow Rate | 1.8 GPM |
| Weight | 17 lbs |
| Model | CM2 HPU |
Guide to understanding indicator light status for HPU.
Details power consumption of CM1 and CM2 hydraulic pumps.
Step-by-step guide for installing the motor cover on C-Monster 1.0.
Step-by-step guide for installing the motor cover on C-Monster 2.0.
Instructions for installing the circuit board on C-Monster 1.0.
Instructions for installing the circuit board on C-Monster 2.0.
Guide for installing the motor assembly on C-Monster 1.0.
Guide for installing the motor assembly on C-Monster 2.0.
Procedures for setting up and operating various C-Monster controllers.
Programming and operation of the surface mount remote control.
Programming and operation of the key fob remote control.
Programming and operation of wireless foot switches.
Operation and installation procedures for the advanced foot switch.
Operation and programming procedures for the advanced key fob.
Instructions for replacing batteries in various controllers.
Step-by-step guide for replacing the HPU reservoir.
Procedures for removing and installing the C-Monster HPU.
Guide to installing 5/16" compression fittings for hydraulic lines.
Instructions for replacing 3/8" hydraulic hoses.
Steps for replacing pump valves on CM1 & CM2 pumps.
Procedure for priming the Power-Pole hydraulic system.
To Next Page