Power-Pole MOVE ZR - Mounting the MOVE ZR

MOVE ZR Installation & Owner’s Guide | 11
MOUNTING THE MOVE ZR
LABEL DESCRIPTION QTY.
2
1/4" x 20, 2 3/4" Stainless Full-Thread Hex Head Bolt
6
3 1/4" Small Stainless Flat Washer
6
4 1/4" Rubber Washer
6
5
1/4" Large Stainless Flat Washer
6
6 1/4" Brass tall Nylon Lock Nut
6
7 Heat Shrink Ring Terminal, 8 AWG, 1/4" 2
8 Heat Shrink Ring Terminal, 8 AWG, 3/8" 2
9 Tech Flow Propeller 1
10 Nut, Nylon Locking Anode, 3/8-24, Assembly 1
11 Shear Pin - Propeller 2
12 Tie-Down Strap 1
TOOLS:
• Fine-tip Marker
• 9/16" Socket
• 7/16” Socket
• 7/16” Wrench
• Ratchet
• Electric Drill
• 5/16” Drill Bit
• Cable Ties (For Units
with Transducer)
NOTICE: Follow Appendix C (p. 42) or instructions on installing the optional Tie-Down Strap
12
.
9
10
11
8
7
12
MOUNTING HARDWARE
2
3
4
5
6