Power Probe IV
www.powerprobe.com · 800-655-3585
Page 3
Safety
• Power Probe recommends reading this manual before using the Power Probe IV.
• This product is designed to be powered from DC power sources such as found in Automo-
tive, Small Craft Marine and Small Craft Aviation electrical systems and will be damaged if
connected to line voltage such as 115V AC power sources or 24V AC Control circuits.
• Do not connect to electrical system with higher than rated voltage specified in this manual.
• Do not test voltage exceeding the rated voltage on the Power Probe IV.
• When testing voltage exceeding 30V AC RMS, 42V AC Peak, or 60V DC, be particularly
careful to avoid any electric shock.
• Check the Probe IV case for cracks or damage. Damage to the case can leak high voltage
causing a potential electrocution risk.
• Check the Probe IV cables for any insulation damage or bare wires. If damaged, do not use
the tool, please contact Power Probe Technical support.
• Use only shrouded leads and accessories authorized by Power Probe to minimize exposed
conductive electrical connections to eliminate shock hazard.
• Do not open the Power Probe IV, no serviceable parts are inside. Opening the Power Probe
IV voids the warranty. All repairs should only be performed by authorized Power Probe ser-
vice centers.
• When maintaining the Power Probe, use only replacement parts specified by the manufac-
turer.
• Use only in well ventilated areas. Do not operate around flammable materials, vapor or
dust.
• Be careful when energizing components that have moving parts, assemblies containing mo-
tors or high powered solenoids.
• Power Probe, Inc. shall not be liable for damage to vehicles or components caused by mis-
use.
• Power Probe, Inc. shall not be held liable for any harm caused by unintentional or intentional
misuse of our products or tools.
• If you have any questions please go to our website www.powerprobe.com or contact Pow-
er Probe’s Technical Support: 800-655-3585.
To avoid possible electric shock or personal injury and to avoid damage to the Power Probe or
item being tested, please use the Power Probe according to the following safety procedures:
CAUTION - PLEASE READ
To Next Page
Loading...
Need help?
General
