Power Probe IV User Manual

Power Probe IV
www.powerprobe.com · 800-655-3585
Tool Repair Operations
Rocker Switch Replacement
Page 20
The Power Probe IV Rocker Switch is used constantly and arcing can occur across the switch con-
tacts and eventually the switch can wear out.
The Power Probe IV also has an Automatic Resetting 8Amp Thermal Circuit Breaker and like the
Rocker Switch, the Circuit Breaker can also wear out over time.If this occurs, the Rocker Switch and
the Circuit Breaker are made to be easily field replaceable.
Replacement Rocker Switches (Part # PN005) and Circuit Breakers (Part # 30-00041) can be pur-
chased from your tool dealer or from Power Probe direct at www.powerprobe.com/webstore/
Follow the instructions below to replace a worn Rocker Switch -
Locate the two slots on either side of the Rocker Switch.
Carefully remove the Rocker Switch with an appropriate pry
tool or small screwdriver. Do not apply excessive force.
Position the new Rocker Switch into the switch cavity and
carefully press straight down until the switch is flush with the
housing.
Slot
Slot

Power Probe IV Specifications

General

Brand	Power Probe
Model	IV
Category	Measuring Instruments
Language	English