17
note that the total power does not exceed the sum of AC and DC power.
DC application
The output voltage of DC socket is 15-20 V, for 12V DC load only.
● When AC power is used, DC power supply can be used.
● Overload of DC may make DC over protector act. Firstly, remove the DC load, wait for a few minutes,
and then reset the button of DC protector.
AC application
1. Start the engine, make sure the AC output light (green) is on.
2. Turn off the power supply switch and plug the device into the generator's output socket.
NOTE: In order to obtain the best operation effect and the maximum service life of the generator, the new
generator should run for at least 20 hours under 50% load, so that the engine performance can be optimized.
Stop The Invert Generator
WARNING: Never stop the engine with electrical devices connected and with the connected devices in
“ON” position.
1. Switch off the connected electrical appliances, and remove the connectors of all electric equipment from
the generating set panel.
2. Turn the engine switch to “OFF” position.
WARNING: Be sure the Engine Switch locate the “OFF” position, when stopping, transporting
and storing the generator.
To Next Page
Loading...
