EasyManua.ls Logo

Power smart HB5035 - Generator Maintenance; Air Filter Maintenance

Power smart HB5035
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
If the engine frequently work under dusty or other severe circumstances, clean the air filter element
every 10 hours; If necessary, change the air filter element every 25 hours.
If maintenance period and the exact time(hour), the one which comes first should govern.
If you have missed the scheduled time to maintain your engine, do it as soon as possible.
Generator Maintenance
WARNING: Never clean the generator when it is running! Never use water to clean the
generating set. Water can enter the generating set through the cooling slots and damage the
generating set windings.
WARNING: Do not modify the generator in any way. Do not tamper with governed speed.
Generator supplies correct rated frequency and voltage when running at factory set. Tampering
with the factory set governor will void your warranty.
Make certain that the generator is kept clean and stored properly.
Use a dry cloth to clean exterior surfaces of the generating set. Use a soft brush to clean the dirt and
oil.
Use an air compressor (25 PSI) to clear dirt and debris from the generating set.
Inspect all air vents and cooling slots to ensure that they are clean and unobstructed.
Changing the oil
WARNING: Change the oil when the engine is warm form operation. The oil can reach up to
140℃under that condition. Careful operation should be taken to prevent burns.
1. Place the machine on a level surface which is about 300mm high
away from the ground.
2. Loosen the cover screw and remove the cover as shown in the right
figure.
3. Place the waste oil box on the ground.
4. Remove the oil dipstick, and tilt the machine to pour the dirty oil
out.
5. Add recommended oil to the upper limit(H) of the dipstick.
6. Reinstall the dipstick tightly.
7. Properly dispose of any used oil at an approved waste management facility.
8. Reinstall the oil maintenance cover.
For conforming to the environment requirement, the used oil will be put into a sealed container and then be
transported to the service station for recycle. Do not throw it into the trash or pour it on the ground.
Air Filter Maintenance
WARNING: Do not run the engine without the air filter, or serious danger can result.
A dirty Air Cleaner will restrict air flow into the carburetor. Please clean and maintain the air
cleaner regularly to prevent carburetor from breaking down,If generators are often used in high dust areas,

Related product manuals