As you can see, the floor panels with the full board will be central (so join with the groove of one panel meeting the
groove of the joining panel) and the cut board will be to the edge of the building –
1. You now need to join the floor panels together.
To do this you will be provided with a number of joining batons to aid you.
Important!
Although the outer bearers will line up, the central bearers may not.
This is completely normal and nothing to be concerned about.
2. For each row of floor panels, turn them upside down and join using joining blocks as follows using a two
50mm screws per joining block to create 8ft floor panels -
To Next Page
Loading...
