Page 19
Select the Fuel Source (Propane/LPG)
1. Fully open the Propane/LPG cylinder knob.
2. Flip the fuel source switch on the side panel to the
propane/LPG position.
RUN
3. Move the choke lever to the “START” position.
START
4. PULL-TO-PRIME
Pull the starter cord 1-2 times to prime the engine.
5. Move the chock lever to the “RUN” position.
RUN
1-2 Times
2. Flip the fuel source switch on the side panel to the
gasoline position.
3. Move the choke lever to the “START” position.
START
5. Do not over-choke. As soon as engine starts and
warms up, move the choke lever to the “RUN”
position. Allow generator to run at no load for few
minutes upon each initial start-up to permit
engine and generator to stabilize.
4. Pull the starter cord slowly until resistance is felt
and then pull rapidly.
To Next Page
Loading...
