Power2max NGeco Manual

Using your power meter
Using your power2max NG
eco
power meter is as easy as the initial operation and installation
is.
BEFORE YOUR RIDE
When your bicycle isn’t being used, the power2max NG power meter is in standby. Once the
crank is moved, the power2max NG
eco
power meter is activated automatically, and it begins
emitting a signal. This is shown by the blinking of the green LED indicator light. Dabei
signalisiert die LED anfangs den Ladezustand der Batterie und im Anschluss die Bereitschaft
zur Verbindung mit einem Bluetooth-Low-Energy-fähigen Gerät (Siehe auch unter „Technische
Spezifikation“, LED-Signalisierung, S. 28)
DURING YOUR RIDE
Your power2max NG
eco
power meter updates all parameters in 1 second intervals; they are
transmitted per ANT+ protocols or BLE.
ZERO-POINT ADJUSTMENT AND THERMAL CORRECTION
To ensure a precise power measurement, the zero-point (the measured value when no
torque is present) is automatically determined by your power2max NG
eco
power meter. The
zero-point adjustment compensates for influences caused by temperature variations and
mechanical zero-point shifts. It is possible to repeatedly set the zero point at the head unit,
but it isn’t necessary! This is performed by the system automatically when it is not under
power. “Not being under power” means a stop in pedaling for at least two seconds during a
ride. If a de-powering as described above is not possible, for example during a long moun-
tain climb, then your power2max NG
eco
power meter automatically compensates for tempera-
ture. Thus your power2max NG
eco
guarantees a reliable power measurement.
WICHTIG:
Bei Bahnmodellen ist der automatische Nullpunktabgleich deaktiviert. Hier sollten Sie regel mäßig
einen manuellen Nullpunktabgleich mittels Fahrradcomputer durchführen.
BATTERY LIFE
Battery life is approximately 400 hours. Battery life can be decreased by low temperatures
and by transporting your bicycle, for example in your car.
AFTER YOUR RIDE
Your power2max NG
eco
power meter independently enters standby mode approximately two
minutes after ending your ride. This reduces electricity consumption and increases battery
life.
power2max NG
Eco
24
English

Power2max NGeco Specifications

Battery

battery life	400 hours
battery charge indicator	3 x green: 60 - 100%, 2 x green: 40 - 60%, 1 x green: 20 - 40%, 1 x red short: 10 - 20%, 1 x red long: 0 - 10%

Transmission and Accuracy

transmission standards	ANT+ Power Only Profile
accuracy	±2%
transmitted data	Power, Cadence

Measurement Range

power range	10 - 2999 W
torque range	0 - 250 Nm
cadence range	30 - 250 RPM