22 PowerBox-Systems − World Leaders in RC Power Supply Systems
- Mode 3:
Extension: all wheel doors open – undercarriage extends – all wheel doors close
Retraction: all wheel doors open – undercarriage retracts – all wheel doors
close
• Number of wheel doors
Enter the number of doors. If all the wheel doors are to be operated by a single val-
ve, enter a 1 at Number of front doors, and leave the Number of rear doors vacant.
• Pause between undercarriage and doors
Extend: The time the system waits after extending the undercarriage before the
wheel doors close. Applies to modes 2 and 3 only.
Retract: The time the system waits after retracting the undercarriage before the
wheel doors close. Applies to all modes.
Once you have completed all these settings, select NEXT.
Note: All settings in the Assistant are stored – including all subsequent servo
positions. For example, if you wish to change the retract mode or the pause
period after completing the Assistant, simply run through the Assistant again
without changing the positions. The Assistant then simply adjusts the timed
sequence.
To Next Page
Loading...
