Copyright © 2022-2023 PowerFlex Systems, Inc. All Rights Reserved. 16
Installation checklist
Identify the location where the PF-JT48 EV charger will be installed at the site
Unbox the PF-JT48 and verify everything is included
Gather all the required tools before going onsite for the installation
Install the PF-JT48 securely to a wall or pedestal
Attach power, communications, and ground bond cables to the enclosure
Ensure all external connections are properly sealed and junction box (and any wires) are
not exposed
Install the charging connector holster (one of two types available from PowerFlex for
cable management)
Install a cable retractor or a high-point anchor (cable management)
Step 3 and 4: Inspection and Validation (usually performed later)
Gather information from the site using the app
Submit site information to PowerFlex with FFF
Get OK to energize and finalize the installation from PowerFlex support
Energize power to the PF-JT48
Collaborate with PowerFlex that end-to-end diagnostics run successfully
To Next Page
Loading...