Copyright © 2022-2023 PowerFlex Systems, Inc. All Rights Reserved. 4
▪ Level (any 9-inch torpedo level will do) to make sure that brackets are installed correctly
▪ Pencil (or magic marker) to mark where drilling should occur
▪ Wrench (or wrench socket) that can work with 3/8" bolt (for cable retractor)
Step 2: Installation
To install the PF-JT48, you’ll do the following:
▪ Mount the EV charger to a concrete wall
▪ Mount the EV charger to a pedestal
▪ Install cable management
Before continuing with any installation, practice this safety measure:
Make sure that electrical breakers are switched off so that no electricity is flowing during installation.
Mounting the PF-JT48 on a wall
This picture shows how the EV charger would look like once installed on the wall (with a junction box):
To Next Page
Loading...