Copyright © 2022-2023 PowerFlex Systems, Inc. All Rights Reserved. 7
8. Connect the chargers’ wires to the circuit branch wires in a junction box, using AWG #6 wire nuts:
Use cable gland waterproof connectors,
if necessary.
You can use a single junction box with
two PF-JT48 chargers.
For safety reasons, make sure that the front opening of the junction box is covered.
The PF-JT48 is now mounted on the wall. To complete the installation, you’ll need to spend a few more
minutes doing cable management.
Mounting the PF-JT48 on a pedestal
Note: The initial mounting instructions for the PF-JT48 charger on a pedestal is similar to mounting
the charger onto a wall.
1. Identify where the charger is to be installed on a pedestal.
▪ PowerFlex recommends that the base of the station should be between 48" and 58" (1.219 m
to 1.473 m) from the ground.
▪ For ADA compliance, the station’s QR code should be no higher than 48" (1.2 m), which means
that the bottom of the station should be no higher than 45" (1.14 m) from the ground.
▪ Make sure that the location of the charger is compatible with the location (or expected
location) of a mounted junction box where the wires from the electrical panel will terminate.
To Next Page
Loading...