PowerMaster rsw Installation Manual

33
V
OR
R
P
Not Used
BL
BK
WH
Y
GR
BR
GY
TO
DRIVEWAY
LOOP
SHADOW LOOP CONNECTION
NOTE: TWIST LEADS APPOX.
6 TURNS PER FOOT.
7
8
9
AB
Red Wire From
Aux. Open Limit
10
V
OR
R
P
Not Used
BLBK WH Y
GR
BR
GY
TO DRIVEWAY
LOOP
NOTE: TWIST LEADS APPOX.
6 TURNS PER FOOT.
EXIT LOOP CONNECTION
2
3
4
5
AB
V
OR
R
P
Not Used
BL
BK
WH
Y
GR
BR
GY
TO
DRIVEWAY
LOOP
REVERSING LOOP CONNECTION
NOTE: TWIST LEADS APPOX.
6 TURNS PER FOOT.
7
8
9
10
AB
34
SAFETY DEVICE CONNECTIONS
INHERENT OBSTRUCTION SENSING DEVICE:
NOTE: The gate MUST move smoothly and easily in manual
operation before attempting this adjustment.
WARNING: TURN OFF POWER TO OPERATOR WHEN
MAKING ANY ADJUSTMENTS.
This unit is supplied with a current sensing system, which
will stop the gate when it encounters an obstruction and then
backs the gate off approximately 2 inches. If the gate is
started again and a second encounter occurs before hitting a
limit switch, the gate will stop and sound a warning signal. A
constant pressure control will then be needed to start the
gate. This sensing system has sensitivity adjustments
located on the printed circuit board. The force required to
activate the system must be adjusted in both OPEN and
CLOSE directions separately. Start at minimum and
increase force setting until it is just over what is required to
move the gate smoothly without any nuisance tripping.
WARNING:
NEVER INCREASE FORCE SETTING TO MAKE UP
FOR A GATE THAT IS NOT MAINTAINED PROPERLY. THIS
WILL DESENSITIZE THE OPERATION OF THE SAFETY
SYSTEM.
MINIMUM MAXIMUM
CLOS E OPEN
OVERLOAD FORCE
R35 R36
LOCATION OF
OVERLOAD FORCE
ADJUSTMENT
Figure 14

PowerMaster rsw Specifications

General

Brand	PowerMaster
Model	rsw
Category	Gate Opener
Language	English