ATTACHING DRIVE CHAIN
1. Install gate brackets at each end of the gate with U-bolts provided.
Do not fully tighten at this time.
2
. Attach a chain take up bolt to one end of the drive chain using a #50
connecting link.
3. Install spring fittings into gate brackets using ¾” nuts and lock
washers. DO NOT tighten.
4. Install chain take up bolt, previously attached to the chain, into
spring fitting in furthest gate bracket. Secure it in position with spring,
spring washer, and ½” elastic stop nut.
PowerMaster
Cement
Pad
Gate
Leading Edge
Gate
Extension
Gate
Bracket
Chain
Support
Bracket
Drive Chain
Gate
Bracket
Chain Support
Bracket
Chain Support
Back up plate
Bolt
Washer
Nut
Gate
Bracket
1/2-13 Elastic
Stop Nut
Spring
Washer
Chain
Tensioning
Spring
Spring
Fitting
3/4 Internal Tooth
Lock Washer
3/4-10 Jamb Nut
Chain take-up Bolt
#50 Connecting Link
Install Chain Support
Brackets As Required
Nut
3/8"
U-Bolts
To Next Page
Loading...
Need help?
General
