Starting the engine
1. Close the flow of chemicals
2. It is impossible to stand in front of the nozzle
SOLVING COMMON PROBLEMS
Heavy engine starts or won't start. Check that the candle is working properly
Problem
No spark
Cause
Water has entered the plug pipe. Electrode
gap too small / too large
Solution
Dry the pipe
Set candle spacing to
0.6-0.7mm
Replace the candle
Clean the spark plug of carbon.
Replace the spark plug
Replace or repair
Replace
Replace
Pass
Reduce the amount of fuel
Change fuel
Contact the fuel. Push down on
the candle pipe
Add fuel
Clean the filter
A pipe of a candle
Broken spark plug insulation
Charcoal on the candle
Burned poles
Cable insulation damaged
Bad coil insulation
Coil wire is faulty The controller is
faulty
Fuel consumption too high
Poor quality fuel
Piston ring and cylinder worn. Spark
plug is too loose. No fuel
Dirty filter
Venting hole in the cap Detect the fuel hole is plugged
The sparker
There is a spark
Low engine power
Cause
Clogged filter
Water in the fuel mixture
Engine overheated
Solution
Clean the filter
Change fuel
Turn off the engine and let it cool
down
Clean the muffler
Change the oil
Change fuel
Carbonized muffler
Bad oil
Bad fuel
10
To Next Page
