Antistatic installation
1.
factors such as type of chemicals, air temperature, humidity. To prevent this from occurring, use the supplied ground
wire.
Dedusting can cause electrostatic charge, it depends on such
Insert one end of the hose into the blow-off pipe while the other end is touching the ground. Connect the other end with
the conductive wire, then screw the conductive wire and the ground wire with screws to the pipe to be bent.
USE
Check it out
1. The cooling hole is not clogged
2. The air filter is not dirty
3. Whether the gap in the candle is 0.6-0.7mm
4. Pull the starter 2-3 times to check that the motor is working properly
Adding fuel
1. Fuel can only be added when the engine is turned off
2. The fuel to oil ratio should be 1:25
3. When refueling, a petrol filter must be installed
Adding chemicals
1.
from the blower, the blower throttle valve and the fuel supply tap should be closed.
When spraying, close the inflow before adding chemicals (Fig. 4). In mode
Fig. 4
6
To Next Page
Loading...
