What causes uneven knife marks on workpiece with Powermatic 60B Power Tool?
Uneven knife marks on your workpiece when using a Powermatic Power Tool can be caused by nicked or misaligned knives. Replace any nicked knives and align the knives properly using the knife-setting gauge.
How to fix stock with slight bevel after edge jointing with Powermatic Power Tool?
If your stock has a slight bevel after edge jointing with your Powermatic Power Tool, the fence may not be perpendicular to the table. Square up the fence with the table.
What to do if my Powermatic Power Tool is causing chip out?
If your Powermatic Power Tool is causing chip out, several factors could be at play. First, ensure you're cutting with the grain whenever possible. Dull knives can also be a culprit, so sharpen or replace them. Avoid feeding the workpiece too fast and make shallower cuts. Lastly, inspect the wood closely for imperfections, and use different stock if necessary.
Why does my Powermatic 60B Power Tool cutterhead slow down while operating?
If the cutterhead on your Powermatic Power Tool slows down during operation, it could be due to a few reasons. You might be feeding the workpiece too quickly or applying too much pressure, so try feeding more slowly and applying less pressure. An excessive depth of cut can also cause this issue, so reduce the depth of cut. Lastly, check your knives; dull knives can cause the cutterhead to slow down, so sharpen or replace them.
How to fix fuzzy, rough, or torn grain when using my Powermatic 60B?
If you're experiencing fuzzy, rough, or torn grain with your Powermatic Power Tool, consider these possibilities. The wood may have a high moisture content, so allow it to dry or use different stock. Dull knives could also be the cause, so sharpen or replace them. Additionally, ensure that the knives are cutting with the grain.
How to get rid of 'chatter' marks on workpiece with my Powermatic Power Tool?
To eliminate 'chatter' marks on your workpiece when using your Powermatic Power Tool, consider the following: Ensure knives are set properly using the provided knife setting gauge and check that knife slots are clean and free of dust or debris. Also, feed the workpiece slowly and consistently.
Why does board thickness not match depth of cut scale on my Powermatic 60B?
If the board thickness does not match the depth of cut scale on your Powermatic Power Tool, the depth of cut scale is likely incorrect. Adjust the scale correctly.
What to do if finished stock is concave on back end with Powermatic 60B Power Tool?
If the finished stock from your Powermatic Power Tool is concave on the back end, it indicates that the knife is higher than the outfeed table. Raise the outfeed table until it aligns with the tip of the knife.
What to do if finished stock is concave on front end with Powermatic 60B Power Tool?
If the finished stock from your Powermatic Power Tool is concave on the front end, it means that the outfeed table is higher than the knife. Lower the outfeed table until it aligns with the tip of the knife.
General| Phase | 1 |
|---|---|
| Type | Benchtop Jointer |
| Motor Power | 1.5 HP |
| Voltage | 230V |
| Cutterhead Speed | 4, 000 RPM |
| Cutterhead Type | Helical |
| Maximum Depth of Cut | 1/8 inch |
| Maximum Width of Cut | 6 inches |
| Minimum Length of Stock | 12 inches |
| Dust Port | 4 inches |
| Speed | 4300 RPM |
To Next Page
